Adding new bike lanes

Open up bike lane cross-section editor
Set up your editor
1. Check your snapping
  1. Calibration Points
  2. Roadway (edge, end, vertex)
  3. Street Intersection
2. Load attribute set (add attribute set file to this page)
Go to the location
Click the Edit tab
Select the route
1. The road is highlighted, letting you know what road will be edited
Select the begin point and end point
1. This signifies the begin and end of where you'll edit bike lane data.
View the best available aerial imagery to base your data entry upon (usually, this is Nearmap_
Select sections to see if any edits are needed

Add Line, Single Yellow Dashed
Add Line, Single White Dashed
Add new Buffer: (Mike Goodno (Unlicensed) - need follow up for complete list)
- Wheelstops, Concrete
- Wheelstops, Rubber
- Wheelstops, Concrete w/Flexposts
- Wheelstops, Rubber w/Bollards

Editing existing bike lanes